1.6 Approval of suppliers of ingredients, packaging, service 1 and outsourced processing and packaging is done at the suppliers manufacturing site level, not at a supplier group level. Supplier Approval & Monitoring Procedure Doc. Id. GTP 010 Date: 22/05/2015 Page: Parts Manufacturer Approval (PMA) Source of Supply ..1-10 Chapter 2 Procuring prescribes the policy and procedures that are to be used to promote and provide for full and open competition, with some exceptions. As defined in FAR 2.101, "full and open What is a PMA? A Parts Manufacturer Approval (PMA) is an FAA design and production approval for aircraft parts. It is only issued after the FAA has (1) reviewed the design of the part to assure that it is safe and meets the requirements of the FAA regulations and (2) reviewed the production quality system to make sure that there is a system in place to verify that each part that is "PMA" is an acronym for "Parts Manufacturer Approval." It is both a design and production approval issued by the FAA. Basically, the FAA permits the manufacture of replacement parts for aircraft if the part has been tested and meets FAA standards for airworthiness and the part is manufactured in accordance with FAA approved procedures. This manual applies contractual terms to suppliers who directly provide Aerospace material (raw materials, production services, component parts and assemblies/systems) to Eaton Aerospace (referred to as Tier 1 or Direct suppliers) unless otherwise exempted by contract or noted in this manual. Production Part Approval Process (PPAP) is used in the automotive supply chain for establishing confidence in suppliers and their production processes. Actual measurements are taken from the parts produced and are used to complete the various test sheets of PPAP. POLICY AND PROCEDURE MANUAL 1. Contact/Ordering information 2. Business Hours 3. Products 4. Prices Parts, LLC within 2 business days of receipt of merchandise and also noted on the Upon approval, returns are to be shipped prepaid to: Dayton Parts, LLC 3500 Industrial Road Good Manufacturing Practices (GMP) Policy Manual Personnel Visitors & Contractors All visitors and contractors must report to the office and must comply with company Health and Hygiene procedure and Induction Procedure. Premises Construction and Layout Air is filtered where necessary and pressure differentials are in place between high and low risk The purpose of the Production Part Approval Process (PPAP) is: To provide the evidence that all SLTN engineering design and specification requirements are properly understood and fulfilled by the Supplier. To demonstrate that the Suppliers manufacturing process has the potential to produce product that so, who is an faa approved source? 14 cfr part 21 certification procedures for products and parts defines production approval methods for aircraft parts: tc - type certificate (including stc's) pc - production certificate tsoa - technical stan