Mold Pre-Heaters and Dryers. General. With the growth of water based flow coating mold washes, the need has arisen for a simple, quick, economical approach to pre-heating and drying molds processed with flow coating. These units are generally mounted with the grid facing a manual or powered 1,Built-in booster pump In order for the mold temperature controller to secure a stable inner pressure, MCHH is provided with an electric booster pump as standard equipment. It exerts stable cooling capacity when cooling down from high temperature. Description: 3/8"-16 ,SQ HD BOLT, ELEMENT MOUNTING HARDWARE HATCO BOOSTER HEATERS. Replaces the following Manufacturer's Products OEM Numbers are used for reference only. checked before troubleshooting any molding problem. If problems are found they should be corrected and the parts re-evaluated before proceeding. Mold - Check the actual mold temperature and its uniformity across the entire mold face and compare with what the temperature was the last time this mold was run in this press. Hatco C 12 Pact Booster Water Heater 208v 3 Phase Kw. China 180 Degree 9kw 12kw Water Heater Hine Mold. 12kw Immersion Heater 2 ? Bsp 3ph 36 Immersed Length. Ao Smith 50 Gallon Gas Water Heater Manual. Water Heater Timer Switch. Phoenix Water Heater Models* PH100-55 / 130-55 / 160-55 / 199-55 This manual must only be used by a qualified heating installer/service technician. or the release of mold, bacteria, or other harmful particulates into the air. Operating a previously submerged appliance could result in Owner's manual; BioSmart BIO-1500PA Owner's Manual . Biosmart breathe easy platium edition far therapeutic infrared heaters. • Heater must not be located immediately below a socket-outlet. • DO NOT use this heater in or around a bath, a shower, or a swimming pool. mold and mildew. Product Description. 628123-S-E75 Ul Mold & Heater Echelon 75Ff. This item and many more appliance repair parts may be available for pick up at our